HiFlo Valves
 
 
 
 
 
 
 
 
 
 
 
 
       
 
Trough Installation:
Flush pipe lines into water troughs before installing Valve into new system
Isolate the water trough to replace valve in existing scheme
Thread O-Ring end of correct size male adaptor into valve body and tighten firmly enough that the O-Ring creates a seal against the face. Do not over tighten.
 
Side Entry   Top Entry
TO CHANGE WATER LEVEL
Adjust length of cord at top of float
 
Side Entry Trough
Thread Valve into existing trough fitting
Screw the Nut with cord onto the
Brass arm
Thread cord through the
float. Tie the cord off to achieve the correct on/off and water level
 
Top Entry Trough
Thread Valve into existing
trough fitting
Screw the float onto the brass arm
Hold the body of the valve at arm
entry point
Bend brass arm to achieve the
correct on/off and water level.
 
 
Click to download The Valve assembly instructions
(Adobe Acrobat PDF)